Energy from flowing water has been harnessed and used for over 2,000 years, beginning with the ancient Greeks using water wheels to grind wheat. In the 1880s, converting a rush of water into electricity became a reality in the United States.
Today, hydropower provides about 80,000 megawatts (MW) of capacity in the United States—enough to power over 25 million average homes—and accounts for about 75 percent of all renewable electricity used by co-ops.
But how does it work? Simply, hydropower converts the natural energy of moving water to mechanical energy, using a turbine that is attached to a generator. With these highly efficient turbine-generators doing the job formerly performed by water wheels, electricity flows in a number of ways:
- Impoundment: When most people think of hydropower, dams come to mind. By plugging a river and amassing water in a reservoir, its flow (and the resulting electricity) can be better controlled and generated as needed.
- Diversion: Water is channeled away from a river, typically near natural falls, down to generators at the falls’ base. This can be done without any visible impact to a river’s natural course. In fact, this kind of generation was used to bring electricity to Buffalo, NY, from Niagara Falls in the late 1800s.
- Pumped storage: This method essentially uses off-peak electricity to make electricity for use during times of high consumption. Two reservoirs are filled, one typically uphill from the other, with an electric pump/generator in between. At night, when demand is low and electricity less expensive, water from the lower reservoir is pumped uphill. During the day, when demand for power increases, that water is released down through the generator to make electricity.
Over 600 electric co-ops across the country buy power from 134 federally-owned and operated dams, most of which were built between the late 1930s and early ‘60s. Despite the incredible importance of these resources, maintenance has lagged in recent years and created room for improvement.
Electric co-ops are making efforts to address this problem, advocating that the government set aside funds to repair and maintain dams and the turbines inside them. Researchers are also looking to create more efficient and fish-friendly ways of generating hydropower. Careful studies of aquatic environments have given dam operators a better idea of how to simulate a natural river downstream.
A 2012 report from the U.S. Department of Energy (DOE) revealed many of the nation’s dams hold untapped power. Roughly 2,500 provide conventional and pumped-storage hydropower in the United States. But the vast majority of dams?some 80,000, ranging from 4 to 770-feet high?are non-powered. The DOE analyzed 54,391 of them.
Locks and dams on the Ohio, Mississippi, Alabama and Arkansas rivers?facilities owned and operated by the U.S. Army Corps of Engineers?offer the most untapped potential. The top 10 sites alone could provide about 3,000 MW.
“Many of these dams could be converted to generate electricity with minimal impact to critical species, habitats, parks or wilderness areas,” the DOE report states.
Co-ops’ efforts in pushing for increased maintenance and technology development will ensure that hydropower remains a reliable and affordable renewable resource for decades to come.